ODROID-C0 CARD

Battery power circuit is fully integrated. Just attach a 3.7V Li+ battery and make it mobile. It is highly suitable for IoT projects, wearables, and other applications that require a lightweight device.

All the ODROID-C1/C1+ OS images are fully compatible with the ODROID-C0. Some of the modern operating systems that run on the ODROID-C0 are Ubuntu, Android, Arch Linux, Debian, and OpenELEC, with thousands of free open-source software packages available. There are also plenty of custom OS available for using the ODROID-C0  as a multimedia center, Kodi, gaming station, headless server and much more at  ODROID WIKI.

The key features and improvements over the original ODROID-C1+:

* Amlogic ARM® Cortex®-A5(ARMv7) 1.5Ghz quad core CPUs
* Mali™-450 MP2 GPU (OpenGL ES 2.0/1.1 enabled for Linux and Android)
* 1Gbyte DDR3 SDRAM
* eMMC4.5 HS200 Flash Storage slot / UHS-1 SDR50 MicroSD Card slot
* 40pin + 7pin GPIOs (unpopulated)
* USB 2.0 Host x 2 (unpopulated)
* Infrared(IR) Receiver (unpopulated)
* Li+ rechargeable battery charger for wearable and robots application
* Battery voltage level is accessible via ADC in the SoC.
* DC/DC step-down converters for higher power efficiency
* DC/DC step-up converter for 5Volt rails (USB host and HDMI) from a Li-Polymer battery
* DIY friendly C0 Connector Pack is available for handy prototyping

The ODROID-C0 is a low cost and light weight variant to the original ODROID-C1+ model.  The PCB size is reduced about 24% and the weight is reduced to 16g from 40g.

– Adding a Li-polymer battery management IC.
– Remove the Gbit Ethernet connectivity.
– Reduce the number of USB host ports to two from four.
– Remove the USB-OTG port.
– Unpopulated a few connectors for various DIY projects.