STM32 Nucleo-64 Development Board

Characteristics

The high performance STM32 F4 series microcontrollers based on the ARM Cortex-M4 with DSP and FPU instructions are an extension of the state-of-the-art STM32 portfolio offering even higher performance.

• 180 MHz Cortex-M4F core STM32F446RET6 microcontroller with 512KB Flash, 128KB SRAM
• Adaptive Real-Time Accelerator (ART Accelerator ™) allows execution with wait states 0 from Flash memory
• 8- to 14-bit parallel camera interface up to 54MB / s
• Arduino Uno V3 connectivity
• ST Morpho extension pin sub-bases for access to all inputs / outputs
• ST-LINK / V2-1 debugger / programmer with SWD connector
• Up to 20 serial communication interfaces: USART, IrDA, I²C, SPI, SAI, CAN, USB, I²S, S / PDIF-Rx, SDIO, HDMI-CEC
• Power options: ST-LINK USB VBUS or external sources
• USB OTG or FS circuit with micro-AB connector
• Random number generator
• CRC calculation unit
• RTC with less than one second accuracy and hardware calendar
• 96-bit unique ID
• 3 LEDs: power supply, USB communication, user LED
• 2 push buttons (user and reset)
• 32.768 kHz crystal oscillator
• Operating frequency up to 180 MHz
• Up to 2 USB 2.0 OTG FS / HS ports
• SDIO (secure digital input / output)
• 16 and 32 bit timers
• ADC up to 3 x 12 bits
• Low voltage: 1.7 to 3.6 V
• ARM mbed Enabled (mbed.org)

Software

• Supplied with HAL library software (and other sample software suites), you can start prototyping immediately.
• With direct access to ARM mbed online resources
• A range of Integrated Development Environments (IDEs) such as GCC, IAR, and Keil IDEs support this development board