USB cable to PIN TTL 4 - פייטל

USB cable to PIN TTL 4

19.00 כולל מע"ממשלוח: 2 עד 5 ימי עסקים

USB to TTL. Used with a Raspberry Pi, a microcontroller or a WiFi router.

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router
serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the
end of the 36″ cable are four wire – red power, black ground, white RX into USB port, and
green TX out of the USB port. The power pin provides the 500mA direct from the USB port
and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level
chipsets.
Because of the separated pin plugs, this cable is ideal for powering and connecting up to
the debug/login console on the Raspberry Pi. Connect the pins as shown to power the Pi
and establish the RX/TX link. Then install the Windows XP/Vista/7/8 or MacOS X
PL2303HX.D drivers on your computer and connect with a terminal program at 115200
baud.
Also handy for hacking WiFi routers to install alternate OS’s, or nearly any other TTL port.
This is easier to use than an FTDI cable in many cases because the wires are separated
This cable is not good for Arduino re-programming such as a Boarduino, MENTA,
Monochron, etc. because it does not have the DTR/RTS wire necessary for initiating the
bootloader reboot sequence. For that we suggest an FTDI cable or FTDI friend.

במלאי

מעוניין לבקש הצעת מחיר?

למה לקוחות קונים אצלנו:

מוצרים באחריות
תשלום מאובטח
משלוחים מהירים
מק"ט: 70060 קטגוריות: ,