The case comes in 9 layers of laser cut Acrylic plate, stacked and screwed together with M3 bolt and nut. You just need to remove the Acrylic plates, insert the Raspberry Pi 3A+ onto base layer and stack the rest of Acrylic accordingly, then screw it back again 🙂 Don’t forget to peel off the protection sheet on every acrylic plate. The USB port (only 1), HDMI, USB microB, Audio/Video jack, microSD card slot, etc are nicely fit and accesible too.
The top layer comes with holes for cooling fan (included), yet that is optional.
The case reserve the space for:
- CSI camera cable
- DSI display cable
- 40-pin GPIO
- Cooling fan and mounting holes
- microSD card slot
- USB microB port for power
- HDMI port
- Audio/Video Composite Jack
- Single USB 2.0 Port
- RAM IC (bottom layer, for heatsink)
Features:
- Easy stack together, only 9 layers
- Black and Transparent layer
- Acrylic plate
- Cut-outs of all connection points
- microSD card cut-out
- Designed for
- Raspberry Pi 3 Model A+
- Raspberry Pi 1 Model A+
- Dimension: 75mm (length) x 65mm (width) x 26mm (height)